>you might also contact harbachelectronics.com, they have a switching unit
>made specifically for the sb200. It's switching voltage is only about 1-2
>volts at a couple mils .!!!!!
> carl / kz5ca P.S. they also have other upgrades for the 200 / 220 etc.I
>have no connection with harbach except as a satisfied customer.
How many turns and what diameter coil for a Harbach Electronics parasitic
suppressor for a 572B? How many ohms for R-sup? Tnx.
>
>----- Original Message -----
>From: "2" <2@vc.net>
>To: "Alvaro E. Rebellon" <arebel@email.msn.com>; " AMPS"
><amps@contesting.com>
>Sent: Saturday, January 25, 2003 10:56 AM
>Subject: Re: [Amps] How to connect the SB-200 to a Kenwood TS-450S
>
>
>> Pin 2 is N.O. -- pin 4 is gnd on Kenwood radios. However, the TS-450
>> will not handle negative or positive 110vdc. The easiest fix is to
>> convert the SB-200 to std positive V switching, and install a NPN
>> transistor in place of the TS-450's amp control relay. See:
>> http://WWW.VCNET.COM/measures/440.html
>>
>> >Can someone please describe to me how is the connection made from the
>> >Heath SB-200 to the Kenwood TS-450S
>> >Thanks All
>> >Alvaro KC6VQH
>> >_______________________________________________
>> >Amps mailing list
>> >Amps@contesting.com
>> >http://lists.contesting.com/mailman/listinfo/amps
>> >
>>
>>
>> - R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
>> www.vcnet.com/measures.
>> end
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
- R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
www.vcnet.com/measures.
end
|