you might also contact harbachelectronics.com, they have a switching unit
made specifically for the sb200. It's switching voltage is only about 1-2
volts at a couple mils .!!!!!
carl / kz5ca P.S. they also have other upgrades for the 200 / 220 etc.I
have no connection with harbach except as a satisfied customer.
----- Original Message -----
From: "2" <2@vc.net>
To: "Alvaro E. Rebellon" <arebel@email.msn.com>; " AMPS"
<amps@contesting.com>
Sent: Saturday, January 25, 2003 10:56 AM
Subject: Re: [Amps] How to connect the SB-200 to a Kenwood TS-450S
> Pin 2 is N.O. -- pin 4 is gnd on Kenwood radios. However, the TS-450
> will not handle negative or positive 110vdc. The easiest fix is to
> convert the SB-200 to std positive V switching, and install a NPN
> transistor in place of the TS-450's amp control relay. See:
> http://WWW.VCNET.COM/measures/440.html
>
> >Can someone please describe to me how is the connection made from the
> >Heath SB-200 to the Kenwood TS-450S
> >Thanks All
> >Alvaro KC6VQH
> >_______________________________________________
> >Amps mailing list
> >Amps@contesting.com
> >http://lists.contesting.com/mailman/listinfo/amps
> >
>
>
> - R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
> www.vcnet.com/measures.
> end
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|