| To: | <amps@contesting.com> |
|---|---|
| Subject: | [AMPS] Reverse-engineering design plate HV |
| From: | jflanders2@home.com (Jerry Flanders) |
| Date: | Wed, 14 Nov 2001 00:26:34 -0500 |
In an old 5CX3000A 1.6-32MHz amp I am working on, the plate blocking caps are rated at 8KV. Can I guesstimate from this what plate voltage was intended? It was made by TMC, presumably to commercial or military specs. If it helps, it has vacuum variable caps in the tank rated at 5KV. Jerry W4UK -- FAQ on WWW: http://www.contesting.com/FAQ/amps Submissions: amps@contesting.com Administrative requests: amps-REQUEST@contesting.com Problems: owner-amps@contesting.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [AMPS] Question - Using 3 phase Xfmr on single phase power?, Jerry Flanders |
|---|---|
| Next by Date: | [AMPS] Coil Forms, <g3sek@ifwtech.com (Ian White, G3SEK) |
| Previous by Thread: | [AMPS] Question - Using 3 phase Xfmr on single phasepower? RESOLVED, Jerry Flanders |
| Next by Thread: | [AMPS] Coil Forms, 2 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |