Amps
[Top] [All Lists]

[AMPS] Re:?: Cooling

To: <amps@contesting.com>
Subject: [AMPS] Re:?: Cooling
From: Jan.E.Holm@telia.se (Jan.E.Holm@telia.se)
Date: Sun, 8 Apr 2001 09:03:27 +0200
I think it´s a good idea to cool the base side.
I run a 3 tube 250B amp on 144 MHz with the tubes
mounted like that (old YU1AW design), however
I also circulate the air in the grid section, i e
the blower first feeds the grid section the air 
comes up thru some holes to cool the anodes and
finaly escape thru teflone cimneys.
Not an answer to your question but still ........

73, Jim SM2EKM
----------------------------------------------------

> 
> A friend asked me this the other day... and, since I don't know, I
> thought I'd ask the list.
> 
>   If a 4CX250 (or similar) tube is mounted with the screen ring 
directly
> grounded by means of a flange (or perhaps finger stock) in a cavity, 
and
> with the anode cooler provided the recommended air supply, then is 
any
> additional cooling required on the base side, to keep the seal 
> temperatures within specs? 
> 
>   Or would conduction cooling from the screen ring to the chassis be
> sufficient?
> 
> 73,
>   Marv  WC6W
> 
> 
> 
> 
> 
> 
> 
> *  
> 
> ________________________________________________________________
> GET INTERNET ACCESS FROM JUNO!
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today!  For your FREE software, visit:
> http://dl.www.juno.com/get/tagj.
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/amps
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
> 


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>