>A question was ask on how I determined the value of the resistor to >use.
>I took the tube manufacture data sheet used the resonant load >impedance
>and driving impedance values. Simply took that value in a >carbon
>composition resistor and attached them to the circuit in there >prospective
>location, I gave the MFJ what it wanted to see in order to >achieve a
>resonant circuit.
>I hope that made sense.
I hope you either did this with tube in place, or used another capacitor to
simulate the Cin, Cout and Cstray.
Otherwise, we might have just found your problem :)
Toll_Free
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|