Amps
[Top] [All Lists]

[AMPS] SB-220: Operate/Standby Switch

To: <amps@contesting.com>
Subject: [AMPS] SB-220: Operate/Standby Switch
From: billp@wwpc.com (Bill Putney)
Date: Fri, 2 Feb 2001 10:03:41 -0800 (PST)
The box I got for this project is dimentonally transendental... It's bigger on
the inside than it is on the outside.

- Bill

On Feb 2,  9:13am, Peter Chadwick wrote:
> Subject: RE: [AMPS] SB-220: Operate/Standby Switch
> Bill said:
>
> >the box has become a place to put all the little things
> >that I needed in the station
>
> It's a good idea - I've done something similar for the
> antenna selection and auto antenna tuner control
>  - but Bill, how do you get it all in one box?
>
> I've got two matching boxes about 12 inches wide
> 6 inches high and 6 inches deep, and they're full
> with all the odds and ends.
>
> 73
>
> Peter G3RZP
>
>-- End of excerpt from Peter Chadwick



-- 
=====================================================================
#  Bill Putney - WB6RFW            | My repeater:443.400 Mhz-100 Hz #
#  WWPC                            | It's not open, it's not closed,#
#  5780 Balmoral Drive             | it's controlled. It's open for #
#  Oakland, CA 94619               | membership (which is free...). #
#  billp@wwpc.com - (510)531-2412  | Go figure...                   #
=====================================================================

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>