> I would guess I have answered my own question - the approximate Plate
> / Load settings are determined at low power (hence less Grid
> over-current when tuning at high power)
>
> > > I seem to recall that the proper way to tune amps. that
> > >were a bit less than stable, was to always start with the
> > >loading capacitor fully meshed.
> >
> > Start with heavy loading/fully unmeshed Load cap. to minimize grid
> > current.
You should start with the loading cap OPEN or unmeshed, not
closed.
The reason the FL-2100 tells you to do otherwise is because the
manual writers probably knew next to nothing about amplifier use.
73, Tom W8JI
w8ji@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|