Why does the FL-2100z manual tell you to start the tune cycle with the load
cap fully meshed?
Then dip the Ip (@ 0.2A), followed by alternate Plate / Load movements to
peak the output.
Then the same at full output.
I would guess I have answered my own question - the approximate Plate / Load
settings are determined at low power (hence less Grid over-current when
tuning at high power)
> > I seem to recall that the proper way to tune amps. that
> >were a bit less than stable, was to always start with the
> >loading capacitor fully meshed.
>
> Start with heavy loading/fully unmeshed Load cap. to minimize grid
> current.
>
> >Perhaps some of our
> >amp gurus can shed some more light on this practice.
> >
> Too light loading is a malprctice, Roger
> >
> end
>
> - Rich..., 805.386.3734, www.vcnet.com/measures.
> end
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|