As I read it, 9KW out using a SO-239 for the output connector???? At 50
ohms that's 671 volts at 13.4 amps.
Now if the amp is 50% efficient it's running about 18KW input for 9KW
out (not including the 1KW from the modified Drake L4-B). From a 230
volt line that's 80 amps! How does a 50 amp breaker switch the HV
on??? (oh, I must have been in error, does it run off of 3 phase 440?)
Gee, I've always been impressed how the 11M bunch can change the laws of
physics.
I don't suppose that PA coil will tune 160M. Looks like a serious 10M
TVI generator to me.
73
Bob K4TAX
Vic Rosenthal wrote:
>
> Radio WC6W wrote:
> >
> > Did someone mention something the other day about the FCC going after on
> > line auctions of questionable radio things?
> >
> > Here is a good starting point:
> >
> > Http//page.auctions.yahoo.com/auction/48826912
>
> Http://page.auctions.yahoo.com/auction/48826912
>
> I put the colon in there so the link will work, because everyone has GOT to
> see
> this. It's a relatively low=powered device (3 x 4-1000a), but the style that
> this guy shows is remarkable. In 44 years as a ham, I've never seen anything
> that better defines "rat's nest" than this...er, amplifier.
>
> 73,
> Vic, K2VCO
> Fresno CA
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|