>
>Pse help, somewhat beginner type questions.... SB-200 to six conversion
>
>1.) I want to work on the input network. I am not perfectly sure abt
>the resistors for tube impedance. If I understand correctly I place
>abt a 200 ohm resistor from the cathode/filament to ground on both
>tubes..., have a 50 ohm termination on the output, close relay and then
>I can use an MFJ 259 analyzer on the input to adjust the input matching
>SWR?. I know no pwr, but with the tubes in place??? Does this sound
>right?
>
>2.) To grid dip the rf choke, do I disconnect it from the circuit,
>short top to bottom and then dip it in place?
Wired into the actual circuit works well.
Rich...
R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|