If the impedance of amplifiers is a "low one or high one", as
credited to professor Areby?:?, then you could prove it with this
simple test.
Put various resistor on the output, and measure the power
delivered. If the PA delivers increasing power as the resistance is
decreased, it is indeed a "low one".
If it delivers increasing power if the load is made higher, it is indeed
a "high one".
My money is on the table that maximum power will occur near 50
ohms in an amp designed to drive 50 ohms near rated output.
That's a simple test that separates the bologna from the truth.
73, Tom W8JI
w8ji@contesting.com
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|