Amps
[Top] [All Lists]

[AMPS] Re: PS diode equalizing

To: <amps@contesting.com>
Subject: [AMPS] Re: PS diode equalizing
From: measures@vc.net (Rich Measures)
Date: Tue, 6 Jul 1999 04:12:36 -0700


>Rich says;
>
>>However, without equalization resistors, there is equal reverse current in
>each >diode -- provided that the diodes are similar.
>
>Not quite - they should be identical. Minor point, apparently, but mixing
>from batches is a no-no.You may well need to use diodes from adjacent sites
>on the same wafer if you are going to push to the rated voltage  limit,
>because of the requirement to get capacities equal. 

?   at 35 or so kHz, this could be important. 

> Choosing diodes for
>equal breakdown voltages can lead you astray. 'Soft' breakdowns don't
>necessarily give the full answer, because break down volts reduces with
>temperature, but they do help. 

?  So use a 50% safety factor.  1N5408s are not expensive.  

> If you're buying your diodes 'loose' you've
>really no guarantee about 'batch' matching; it's slighty better if you buy
>them bandoliered, but there's still no guarantee. I suspect that using
>under-voltage rated resistors is probably worse than using a bandolier of
>diodes and no resistors.
>
? I agree.  



Rich...

R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures  


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>