> ? If input contact arcing takes place, transients are fed to the input of
> the amplifier tube. If these transients stimulate intermittent vhf
> oscillations, it doesn't matter if the output relay contacts are closed or
> not since vhf energy can not pass through the low-pass hf tank. > -
> cheers, Tom
More typical nonsense and distortion of fact by omission, or else
you don't understand grounded grid PA circuitry.
Either way, your advice is incorrect.
The input circuit is AFTER the relay and BEFORE the tube. If the
input circuit is properly designed and implemented, VHF energy
could never make it to the tube.
Even if there was no input circuit, the tubes have almost no gain at
VHF when cathode driven. That's because the grid is parallel
resonant at VHF. Few people use 3-500's as two meter amplifier
tubes, although they can be used as TPTG oscillators at 180 MHz.
Finally, the VHF energy from the small arc on the input contacts
would never be large. VHF energy would have to be many many
times less than the HF energy.
73, Tom W8JI
w8ji@contesting.com
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|