>
>Congrats to Jon, KE9NA, on the 4-1000 amp. Hey, if it works like you said,
>don't ask questions, just knock on wood, good job! I am surprised that the
>series L in the plate connection didn't just move that 80 Mhz resonance
>that you've seen in the past, down by 10-20 MHz. You said there is no
>noticeable dip from 50 to 150 MHz.... What about just below 50? I am amazed
>that there isn't a big resonance due to the L and the first tank C, or the
>tube output C and the L and first tank C to ground.
When measuring the anode with the dip meter here is what I saw
(approximately, it's been about a week since I measured it):
Resonance at 28 MHz - tank circuit was tuned to 10M
Resonance in the high 30 MHz range - plate choke
Resonance around 50 MHz - yes this could be the anode, but I think it is
the resonance in the "L" coil.
Circuit is completely clean and clear of resonances from 50 MHz until 150
MHz. In the past a rather good resonance could be seen around 80 MHz.
So perhaps I did move it lower. Whatever the case, the amp is stable.
And I tried the stability test of keying the amp with no load and moving
Ctune thru its entire range.
AG6K's cathode suppressors did work very well. W/O those, the amp was
not stable but oscillated easily.
Someone pointed out to me that an oscillation can occur in an amp when
there is a low reactance from the anode to ground. With the "L" coil in
place, it has such a high reactance at VHF, that the anode won't see a
low reactance to ground.
>
>> IMHO, my theory on the "L" coil adding to the stability
>>was correct. It completely looks like a very large reactance to any VHF
>>energy. And when checking the anode circuit with a dip meter, I could
>>not find ANY noticeable dip from 50 to 150 MHz. With all my previous
>>anode/tank circuit designs, I had a nice dip about 80 MHz. The resonant
>>capability of the circuit at VHF is gone.
>
>So when I read your observation, I think that it is still somewhere, just
>that you moved it. And your jug just doesn't want to oscillate there!
Well, correct. I am not sure where it moved, but who cares!
> I
>forget if you are running grounded cathode or grounded grid? Whatever
>you've done, consider yourself blessed, and go on to bigger and better
>things. Maybe will hear you on HF.
Grounded grid.
Yes, maybe you will! I've been getting good reports on it.
Thanks for the note.
73,
Jon
KE9NA
--------------------------------------------------------------------------
Jon Ogden
jono@enteract.com
www.qsl.net/ke9na
"A life lived in fear is a life half lived."
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|