hi john,
i always enjoy reading your posts about *real* amps, tetrodes where
even the handles have handles!
<snip>
> Setting the plate
> current identically, using the screen voltage, results in greatly differing
> RF output. So a compromise was found, with one screen at 1300 and 1600 on
> #2. With that, the RF was close on each side.
i'd LOVE to know if the RF output would be the same (close?) if you
used the SAME screen voltage, and different CONTROL GRID bias to
obtain equal plate current. is there any chance you could check
this????
vy 73,
George T. Daughters, K6GT
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|