Hello to everyone on here.
I have been following the threads for a while now and finally have a
question. I am currently building a single 4-1000 amp and have 3 tubes
all used and supposedly working when removed from original service.
How can I test these besides putting them in the amp and seeing output?
Is there any way to check them alone. I have access to basic test
equipment, multimeter, o-scope, sig gen, freq counter, megger, hi
pot.......
I would appreciate any information from the group.
thanks in advance.
73/dx Tim KB2MFS
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|