Issue resolved. Reset hex address back to default value and all is fine.
Thank you to all who responded with suggestions. Thank you especially to
Mohamed CN8KD for bringing up the default address issue. CU all in the
next RTTY contest.
Karl
K0CIE
---------- Forwarded message ----------
From: Karl Kaukis <karl@kaukis.com>
Date: Wed, Mar 7, 2012 at 2:59 PM
Subject: IC7000 Cat Port
To: writelog@contesting.com
Trying to configure CAT for IC7000 and WL. CAT works fine with most other
programs. WL does not see the 7000. WL opens cat port as 2 stop bits
instead of 1 as is correct and as other programs do. Is that the problem?
What do I do?
--
Karl Kaukis
6714 E. 19th Ave.
Stillwater, OK USA 74074
Phone: 405-334-1511
FAX: 877-334-1511
Skype: karl.kaukis
karl@kaukis.com
--
Karl Kaukis
6714 E. 19th Ave.
Stillwater, OK USA 74074
Phone: 405-334-1511
FAX: 877-334-1511
Skype: karl.kaukis
karl@kaukis.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|