I recently replaced my PRO3 with an FT-2000D.
My recollection is that %O used to work properly when I had an FT-1000MP,
but it's not working the way it should with my FT-2000D. It turns off the
RIT and doesn't clear the offset instead of clearing it and leaving the RIT
on, which I think it should do. Am I confused about how it should work or
is there another command?
Jim N7US
-----Original Message-----
There is no RIT zero software command with the Icom rigs. <dag-nab-it!>
Eric - Ve3gsi
> -----Original Message-----
> From: Nicholas Roy Smith
> Sent: January-18-09 3:14 PM
>
> Did a fix for the Icom RIT clear ever get done? * ? Or %O for Icom?
>
> Just picked up a couple of Icoms and really miss that feature.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|