I have trcvr Kenwood TS950SDigital S/N 0120097. The
problems appears during controling the trcvr through
interface IF232C.In my experiments I used the
different PC's (Celeron 300MHz and P4 2.24Ghz)and
different OS (Win98 and Win2000Proffesional).
WL PORTs window settings were COM1-Kenwood (in other
case Kenwood TS850),4800 boud .
WriteLog reads the trcvr's frequency and shows it in
the FREQ window. At this stage all passes orderly,
but...
The TS-950SD does't control by WL if switch the bands
(AltF1, AltF2),Modes does't change (CtrlF1 CtrlF2),
TS950 does't change it's freq if I enter it directly
into QSO Entry window or by means of GrabSpot.
Also I had NO a PTT keying on comm port. Keying on LPT
port is working OK.
I know that this problem was already discussed here
and
I searched archives, but unfortunately did not find
helpful information.
Any ideas?!
Dan / RA6CO member of RM6A team.
P.S. I had tested TS950SD +IF232C with LOGGER (W98 OC)
and K1EA(CT)in DOS mode , all works fine.
__________________________________
Do you Yahoo!?
Yahoo! Mail Address AutoComplete - You start. We finish.
http://promotions.yahoo.com/new_mail
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|