Hello,
I have the latest Write Log and I am using Windows 2000 with my Dell
Latitude Laptop.
I use LPT1 to generate CW and this works very well with QSK when using
Full-Break-In on my FT-1000D.
I also have a USB to Serial converter box from MIcroham.
This box allows me a virtual port COM 4. The output of this converter box
has a 6 pin din connector that connects to the FT-1000D CAT jack for Rig
control
This virtual COM 4 port works very well also for controlling my FT-1000D Rig
frequencies with Writelog.
HOWEVER, The problem is that I cannot select LPT 1 for CW and COM 4 for Rig
Control at the same time.
There is only one COLUMN under the Ports Setup Page for selecting COM 4 or
LPT 1.
I would like to see another column of entries, so that both LPT 1 for CW
and COM 4 for RIG Control can be set at the same time.
So, right now I can only select LPT 1 or COM 4 and not both.
Thanks,
Jim
K4PV
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|