Garry,
Try the following:
1. Open up WRITELOG.INI (Start Menu, Run, type in WRITELOG.INI <ENTER>).
2, Find the [PORTS] section and add CW_ON_PIN1=1 line:
[PORTS]
CW_ON_PIN1=1
73,
Alan N5NA
----- Original Message -----
From: "Garry Shapiro" <garry@ni6t.com>
To: "WriteLog Reflector" <writelog@contesting.com>
Sent: Monday, May 27, 2002 0:16 AM
Subject: [WriteLog] Erratic Cw
> Would someone point me in the right direction on this one?
>
> So far, I have "dabbled" with WL--a serious Sweepstakes effort, both
modes,
> and lesser participations in several other contests. In CW WPX, I
> encountered a condition that I am sure is familiar to many of you, but was
> new to me. In sending CW from the program, I frequently experienced
delayed
> characters, stretched-out characters, etc. In fact, I often sounded like a
> total klutz. As I said, I don't recall experiencing this before.
>
> The computer is a 550 MHz P3, 256 MB RAM, plenty of H/D space. I run Win
98
> SE, and use LPT1 for CW, with the same cable and transistor switch I have
> used for a decade with CT, without incident. I turned off every other
> software program except AtomTime--which only updates upon request. (I need
> to keep that one active because two identical ABIT motherboards have each
> had wandering real-time clocks.)
>
> Garry, NI6T
>
>
>
> __________________________________
> 160 meters---not a band but an obsession
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|