Sorry Jim, but I have to disagree with you on the carrying cases. I
find them very convenient. I just returned from another week on Bonaire
and simply threw the cases and analyzer in my backpack for travel. The
cases are small dollar insurance for anyone who believes that portable
means to move the devices off the bench!
73 charlie, k1xx
On 6/6/2019 2:20 PM, Jim Brown wrote:
On 6/6/2019 9:45 AM, Máximo EA1DDO_HK1H wrote:
But, if you can afford it, you can go to a mighty KC901, a two ports
true vectorial VNA:
I've owned and loved this Vector Network Analyzer for about five
years. Very well supported by the designer, EE prof DG8SAQ, and by the
small company run by British hams that build and sell them. I
recommend the VNWA3EC, Cost is $526.
https://www.sdr-kits.net/introducing-DG8SAQ-VNWA3
The same company also sells this very nice Vector Antenna Analyzer. I
bought one last fall, and like it a lot for more portable operation.
Cost is $185 plus shipping.
https://www.sdr-kits.net/VA5_Page
The VNWA is built and tested. The FA-VA5 is a kit that took be about
three hours to build. Both units can do precision TDR measurements
when run from a computer using DG8SAQ's software.
The difference between a Vector NETWORK Analyzer (VNA) and an Vector
ANTENNA Analyzer (VAA) is that the VNA can measure the GAIN (or loss)
in a system or device. For example, it can measure the isolation
between antennas, and the response (rejection) of bandpass filters.
Both can measure impedance and do TDR (that is, find faults in a
feedline). With a well designed test fixture, a good VNA can also
measure high values of impedance with greater precision than a VAA. I
use the VNWA to measure multi-turn ferrite common mode chokes for use
at HF.
For either analyzer, I do NOT recommend the carrying case, and I DO
recommend the better BNC calibration kit listed with the FA-VA5. As I
recall, shipping was in the range of $25-$35 to my QTH near San
Francisco. They ship by British mail, and it comes via USPS.
A major advantage of the VNWA and FA-VA5 is that both can be powered
from the USB port of the computer that runs the software. The FA-VA5
can also be used "stand-alone" on a pair of internal AA batteries.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|