Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tool for F-connector holes

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Tool for F-connector holes
From: Steve Bookout <steve@nr4m.com>
Date: Mon, 11 Mar 2019 19:56:27 -0500
List-post: <mailto:towertalk@contesting.com>
Tony,

Now, that you've seen the ideas, you may want to rethink using that connector.   It is so easy to use the type F connector WITH A MOUNTING FLANGE.

4 - #4 machine screws or sheet metal screws will hold it in place.  I feel your pain when it comes to those cheesy connectors rotating when you tighten them.    And, the typical 'bargain basement' connectors have pot metal nuts that are useless.  Any amount of torque and they crumble, literally.

Consider the flanged ones...

73 de Steve, NR4M

On 3/11/2019 5:34 PM, tony.kaz--- via TowerTalk wrote:
Does anyone know of a tool that makes a nice hole in Carlon boxes for a
female F-connector with two flats that makes a nice hole so the connector
doesn't spin?

Tnx

N2TK, Tony

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>