If you want the job done properly, take it to a machine shop. Otherwise,
just use a regular drill bit and tighten with a star lock washer to prevent
spinning.
I think you will find the proper tool too expensive to justify purchase.
73, Keith NM5G
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of tony.kaz---
via TowerTalk
Sent: Monday, March 11, 2019 5:34 PM
To: Towertalk <towertalk@contesting.com>
Subject: [TowerTalk] Tool for F-connector holes
Does anyone know of a tool that makes a nice hole in Carlon boxes for a
female F-connector with two flats that makes a nice hole so the connector
doesn't spin?
Tnx
N2TK, Tony
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|