We just purchased 6 from Mouser Electronics - panel mounted Cinch plugs
Dick
Visit "The Barnstormers Contest Group - NZ1U"
website http://www.qsl.net/kb1h/
24/7 Webcam Link on the website
Email KB1H@arrl.net YCCC----> http://www.yccc.org/
KB1H DXSpider Node ------> dxc.kb1h.com port 7300
2 Meter access on 144.930 Mhz.
NZ1U-3 Skimmer -----> dxc.kb1h.com port 7303
----- Original Message -----
From: <n8de@thepoint.net>
To: "Kurt Cathcart, KR2C" <Kurt@KuhlRoad.Net>
Cc: <towertalk@contesting.com>
Sent: Wednesday, November 03, 2010 12:36 PM
Subject: Re: [TowerTalk] wall plate jack for the 8 wire rotor cable
> Cinch-Jones makes panel connectors of the type you desire.
> They are sometimes available on eBay .. prices can be steep.
>
> 73
> Don
> N8DE
>
>
> Quoting "Kurt Cathcart, KR2C" <Kurt@KuhlRoad.Net>:
>
>> Currently I have my Hy-gain rotor cable coming through a hole in a
>> stainless steel wall plate with a grommet. I have wound up on the
>> floor a bunch of excess cable before it goes to the control box. Does
>> anybody make a good connector that I could mount in the wall plate so
>> that I can use a shorter jumper cable from the wall to the control box?
>> this way I wouldn't have to worry too much if I should re-arrange the
>> shack.
>>
>> -Kurt
>> KR2C
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|