[TowerTalk] wall plate jack for the 8 wire rotor cable

["Kurt Cathcart, KR2C" <Kurt@KuhlRoad.Net>]

Currently I have my Hy-gain rotor cable coming through a hole in a 
stainless steel wall plate with  a grommet.  I have wound up on the 
floor a bunch of excess cable before it goes to the control box.  Does 
anybody make a good connector that I could mount in the wall plate so 
that I can use a shorter jumper cable from the wall to the control box?  
this way I wouldn't have to worry too much if I should re-arrange the shack.

-Kurt
KR2C

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk