The drill size is a #7 drill (.201")
Charles, KC9DAO
Penninger Radio
^
^
----- Original Message -----
From: "r miles" <greenacres113@charter.net>
To: "antennas" <antennas@mailman.qth.net>; "towertalk"
<towertalk@contesting.com>
Sent: Thursday, March 11, 2010 1:05 PM
Subject: [TowerTalk] pipe tap drill size
>I am putting two gusset plates to hold truss supports on my homebrew 30m
>Moxon. I'm using 1/4'' X 20 bolts. It's been 40 yr.s since I worked in a
>machine shop. Don't have the proper hole size chart for taps anymore. I
>assume the hole size to be threaded 1/4 x 20 is less than 3/16''. Anyone
>have a chart showing the proper size.TNX
> K9IL
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|