Ted-
My solution was to add an Idiom Press EZ-Rotor mod with serial IO to the
rotor control. Now I can control the rotor from any PC on the net. (I
actually have all three of my rotor on serial ports).
-Tony
----- Original Message -----
From: <k2qmf@juno.com>
To: <towertalk@contesting.com>; <yccc@yccc.org>
Sent: Wednesday, February 24, 2010 7:40 PM
Subject: [YCCC] Dual rotor controllers
> Hello All,
>
> I asked this question years ago and got replies.
> However, I can't find them. Guess they are on an
> old computer.
>
> Anyway, I would like to know how I can connect
> two (2) controllers to one antenna rotator???
>
> The rotator is a HAM-4 and I have 2 controllers.
>
> I want to be able to control the rotor from 2 different
> operating positions...
>
> As I recall, you need to take the fuse out of one of
> the controllers. I don't remember anything else...
>
>
> Any help would be very much appreciated.
> Thank in advance.
>
> 73,
> Ted K2QMF
>
> P,.S. - I tried the archives with no luck.
> ____________________________________________________________
> Senior Assisted Living
> Put your loved ones in good hands with quality senior assisted living.
> Click now!
> http://thirdpartyoffers.juno.com/TGL2141/c?cp=7EABkAGHgyj9SYLGBMm_uAAAJ1BnGn6THZj3zb9oqpzij_rqAAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAASUQAAAAA=
> _______________________________________________
> YCCC Reflector mailto:yccc@contesting.com
> Yankee Clipper Contest Club http://www.yccc.org
> Reflector Info: http://lists.contesting.com/mailman/listinfo/yccc
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|