Got any scrap metal yards around ? We have one here and I can usually
find Panels for scrap prices.
73, Dick, W1KSZ
> Date: Thu, 21 Jan 2010 10:33:46 -0800
> From: jimlux@earthlink.net
> To: richard@karlquist.com
> CC: towertalk@contesting.com
> Subject: Re: [TowerTalk] Aluminium wanted
>
> Rick Karlquist wrote:
> > Jim Lux wrote:
> >> They want a bit more than $8 for some .090 thickness 3003 alloy.. roughly
> >> the same price as McMaster Carr..
> >>
> >> It *is* a commodity, so all the sources are going to be in that ballpark.
> >
> > My experience with McMaster is that their prices
> > are all over the map. Sometimes competitive, often
> > prohibitive unless you MUST have some item. For
> > example, a screw with a slotted head might be
> > cheap, and the same screw with a Philips head might
> > be very expensive. Long screws are much more expensive
> > per inch than short ones. Sheet metal, etc is all
> > over the place in terms of $/lb. Again you will find
> > that certain dimensions have a threshold where the
> > price suddenly goes way up. You need to have the right
> > paradigm to deal with McMaster. Be flexible. Plan on
> > spending a LOT of time searching and comparing prices.
> > Maybe even change your design to work with what they
> > have. I have done that many times.
> >
>
> It also depends on what your time is worth. If you're buying something
> at work, and you're burning $100/hr burdened cost, spending an hour to
> save $10 is a poor economy. I think McMaster-Carr is well aware of
> this. Their big virtue is that they seem to have an amazing variety and
> fast delivery.
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|