Towertalk
[Top] [All Lists]

Re: [TowerTalk] Swedging

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Swedging
From: "dan" <longterm@chatusa.com>
Date: Sun, 28 Oct 2007 22:32:59 -0000
List-post: <mailto:towertalk@contesting.com>
Reduction in size of aluminum tube end so smaller size will fit swedging. I 
want to reduce each taper by 1/8 inch 2 to 1 /7/8  1 /7/8 1 5/8 etc

Dan NN7J
----- Original Message ----- 
From: "dan" <longterm@chatusa.com>
To: <towertalk@contesting.com>
Sent: Sunday, October 28, 2007 7:41 PM
Subject: [TowerTalk] Sweding


> Looking for ideas on swedging, have  hyd 200 ton press. Like to swed 2 
> inch to 1/2 inch Al tube.
>
> Dan NN7J
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> 


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>