Towertalk
[Top] [All Lists]

Re: [TowerTalk] Swedging

To: "dan" <longterm@chatusa.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Swedging
From: "Dan Hearn" <dhearn@air-pipe.com>
Date: Sun, 28 Oct 2007 17:22:56 -0700
List-post: <mailto:towertalk@contesting.com>
Dan, if your swedging scheme does not work out you can buy tubing from Texas
Towers in 1/8 inch steps from 2 inch down. It has .052 wall so makes
excellent short bushings to use at each joint. I usually do a saw slot
length wise at each joint in the tubes and clamp down with hose clamps. They
have ads in CQ and QST showing the tubing info.  73, Dan, N5AR

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of dan
Sent: Sunday, October 28, 2007 3:33 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Swedging


Reduction in size of aluminum tube end so smaller size will fit swedging. I
want to reduce each taper by 1/8 inch 2 to 1 /7/8  1 /7/8 1 5/8 etc

Dan NN7J
----- Original Message -----
From: "dan" <longterm@chatusa.com>
To: <towertalk@contesting.com>
Sent: Sunday, October 28, 2007 7:41 PM
Subject: [TowerTalk] Sweding


> Looking for ideas on swedging, have  hyd 200 ton press. Like to swed 2
> inch to 1/2 inch Al tube.
>
> Dan NN7J
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>