When I was a kid, I used a standard hacksaw, then deburred with a round
file.
Worked fine. 73 - Rich, KE3Q
----- Original Message -----
From: "Tim, N9PUZ" <n9puz@arrl.net>
To: <towertalk@contesting.com>
Sent: Monday, July 19, 2004 4:31 PM
Subject: Re: [TowerTalk] Cutting slots in aluminum tubing ?
On Mon, 19 Jul 2004 19:50:51 +0100, Steve London wrote:
> Anyone have any tips for cutting slots in aluminum tubing without
> having a full machine shop at your disposal ?
I have used small milling bits chucked into a normal drill press
before. An economy type drill press and a machinists type vise that
lets you move the work around (from Harbor Freight or somewhere
similar) can get a lot of hobby work done without the expense of a
real mill.
If you just need a couple of slots maybe a Dremel tool with a cutoff
wheel and some small files to clean up the edges will get you by.
Tim, N9PUZ
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|