[TenTec] Omni 6 Plus problem

[Michael Marx <sndtubes@vacuumtubes.com>]

Hi guys,

Unfortunately, my newly acquired Omni 6+ just “blew up”.  It was working fine.  
Then I noticed the display was a missing digits and segments.  I figured I just 
needed to re-seat the connectors which I did.  When I turned it back on, the 
dial lights flashed up brightly and then dimmed.  At that point, all of the 
LED’s on the panel were lit and nothing else.  Any suggestions on what I should 
do now?

73
Mike WB0SND


Michael Marx
sndtubes@vacuumtubes.com
636-939-9190