Had that happen once after having mother board out.
Turned out one of connectors to front panel needed re seated
Paul K0UYA
-----Original Message-----
From: Michael Marx
Sent: Wednesday, May 24, 2017 8:10 PM
To: TenTec@xxxxxxxxxxxxxx
Subject: [TenTec] Omni 6 Plus problem
Hi guys,
Unfortunately, my newly acquired Omni 6+ just “blew up”. It was working
fine. Then I noticed the display was a missing digits and segments. I
figured I just needed to re-seat the connectors which I did. When I turned
it back on, the dial lights flashed up brightly and then dimmed. At that
point, all of the LED’s on the panel were lit and nothing else. Any
suggestions on what I should do now?
73
Mike WB0SND
Michael Marx
sndtubes@xxxxxxxxxxxxxxx
636-939-9190
_______________________________________________
TenTec mailing list
TenTec@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/tentec
|