[TenTec] Matching impedance on Argonaut 509 microphone

[Jeff Genung <searust@gmail.com>]

I bought a low impedance Astatic mic for my Argonaut 509, but no where in
the manual does it say how high the impedance needs to be. Should I try to
match this with a small audio transformer in the mic or do I not need to
worry so much. I think the only issue may be lower volume? maybe I could
put the transformer in the rig? Or should I maybe get a whole speech
processor? Ideas?

Jeff Genung.
WD5EOD
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec