TenTec Eagle ACC1 "Y” splitter
On the TenTec Eagle ACC1 DIN accessory connector there are pins for AMP KEY (8)
and LINE_IN/OUT (1/2).
See:
http://www.tentec.com/wp-content/uploads/2016/05/tt_599_manual_v1.009.pdf#page=23
Seems there should be no reason why AMP KEY and LINE_IN/OUT cannot be used
simultaneously if one wanted to run digital modes AND key the amp (not a usual
practice of course). Or just for the convenience of not swapping cables.
The TenTec 318 Amp Keying Interface has these dual DIN sockets too, but adds
other features not needed at the moment.
So planning to use a DIN “Y” splitter cable (such as this:
http://preview.tinyurl.com/MWRYCRET)
Any reason this would not work? Thanks.
Ryan, K5TXT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|