TenTec
[Top] [All Lists]

Re: [TenTec] Orion's break in

To: TenTec reflector <tentec@contesting.com>
Subject: Re: [TenTec] Orion's break in
From: art davis <n4uc@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 18 Nov 2011 00:15:59 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I'm sure. When I'm wearing headphones (no external audio), my wife can hear it 
in the next room!

> Date: Wed, 16 Nov 2011 06:50:37 -0500
> From: n4py2@earthlink.net
> To: tentec@contesting.com
> Subject: Re: [TenTec] Orion's break in
> 
> Are you sure that is relay noise and not an actual receiver chirp from 
> the AGC action?
> 
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
> 
> 
> On 11/15/2011 10:53 PM, art davis wrote:
> > The key word there is "most". The T/R relay in my Orion 565, which operates 
> > with every character, is so noisy I can hear it in the next room when the 
> > sidetone is turned off. I wouldn't characterize it as "clacking" though, 
> > more like chirping. And it makes the noise when the relay relaxes, not on 
> > the make. VERY annoying! I'll bet that's what he's talking about.
> >
> > N4UC
> >
> >> Date: Mon, 14 Nov 2011 08:40:48 -0500
> >> From: n4py2@earthlink.net
> >> To: tentec@contesting.com
> >> Subject: Re: [TenTec] Orion's break in
> >>
> >> The antenna relay always follows the keying.  But for most Orion's, the
> >> antenna relay noise is barely audible.
> >>
> >> Carl Moreschi N4PY
> >> 121 Little Bell Dr.
> >> Hays, NC 28635
> >> www.n4py.com
> >>
> >> On 11/14/2011 8:32 AM, Floyd Sense wrote:
> >>> I delayed both - no difference.
> >>>
> >>> K8AC
> >>>
> >>>
> >>> On 11/14/2011 8:22 AM, Barry N1EU wrote:
> >>>> I only tried delaying one of the EXT TR relays and it made no
> >>>> difference on the relay clacking - I didn't try delaying both of them.
> >>>>
> >>>> On Mon, Nov 14, 2011 at 8:04 AM, Rick - DJ0IP / NJ0IP<Rick@dj0ip.de>    
> >>>> wrote:
> >>>>> Barry, if you delay those relays, they won't follow the cw keying and 
> >>>>> they won't clack.
> >>>>>
> >>>>>
> >>>>> -----Original Message-----
> >>>>> From: tentec-bounces@contesting.com 
> >>>>> [mailto:tentec-bounces@contesting.com] On Behalf Of Barry N1EU
> >>>>> Sent: Monday, November 14, 2011 2:00 PM
> >>>>> To: Discussion of Ten-Tec Equipment
> >>>>> Subject: Re: [TenTec] Orion's break in
> >>>>>
> >>>>> Right, but he's asking specifically about the audible relay clacking.
> >>>>>
> >>>>> Barry N1EU
> >>>>>
> >>>>> On Mon, Nov 14, 2011 at 7:51 AM,<d.e.warnick@comcast.net>    wrote:
> >>>>>
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>>
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> >                                     
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
                                          
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>