Dear all,
I want to submit a problem occurred to my Orion I transceiver.
The radio has installed the firmware version 2.062a with the v2 hardware
modification to the Logic/DSP board.
I haven't any problems with the radio since last week but now the sub-receiver
seems dead and I listen only a bad noise.
I realized that because the SPLIT function was ON and I don't listen nothing on
one ear.
I have re-loaded the software and initially the radio seems to work properly
but after I switched off it the sub-receiver doesn't work at all.
Nothing happen after a Master reset or Ram clear.
So, I don't know what happen and I would like to know what I should do.
Could you help me please? May I have a suggestion from your side? Did it
already happen to anybody else?
I thank you in advance for your attention.
Best regards,
Giuseppe CROSTA IZ2ABU
P.S. I submitted this message also to Ten Tec service and I hope to receive
some info from Paul.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|