Do you have an antenna selected for SUB RX?
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "G.C." <g.crosta@tin.it>
To: "TEN TEC LIST" <tentec@contesting.com>
Sent: Saturday, October 13, 2007 2:53 PM
Subject: [TenTec] Orion 1 sub-receiver problem
>
> Dear all,
>
> I want to submit a problem occurred to my Orion I transceiver.
>
> The radio has installed the firmware version 2.062a with the v2 hardware
modification to the Logic/DSP board.
>
> I haven't any problems with the radio since last week but now the
sub-receiver seems dead and I listen only a bad noise.
>
> I realized that because the SPLIT function was ON and I don't listen
nothing on one ear.
>
> I have re-loaded the software and initially the radio seems to work
properly but after I switched off it the sub-receiver doesn't work at all.
>
> Nothing happen after a Master reset or Ram clear.
>
> So, I don't know what happen and I would like to know what I should do.
>
> Could you help me please? May I have a suggestion from your side? Did it
already happen to anybody else?
>
> I thank you in advance for your attention.
>
> Best regards,
>
> Giuseppe CROSTA IZ2ABU
>
> P.S. I submitted this message also to Ten Tec service and I hope to
receive some info from Paul.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|