Guys,
I have a new laptop at work and as usual I had a share of WIN98 installed in
the event that I wanted to run NA during a test. Unfortunately, the laptop
(Compaq NC6000) is so new that WIN98 is not supported.
My problem is that I can't get NA (v10.59) to key my TS830. I have the same
configuration (IRQ, etc.) in this version of NA as I had for version 10 so I
think that issue is cleared.
I'm looking for help to set the right parameters within WIN98 to make the
keyer work.
Any help getting me back on the air would be greatly appreciated.
Thanks & 73,
Roger ...
KA9EKJ
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Roger Hoeft
Senior Systems Consultant
<<...OLE_Obj...>>
(256) 730-1662 (256) 730-1350 (fax)
Roger.Hoeft@intergraph.com
http://www.intergraph.com <http://www.intergraph.com>
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|