Dick,
Are you sure you are looking at the run line of the macro? Mine reads:
F2 REPORT,{TX}{ENTER}! 599 66 66 {RX}
And it does exactly that. New line, sends call etc.
John GW4SKA
Hi guys,
The ARRL RTTY Roundup was an excellent way to start the 2016 contest
season! If we worked, thanks for the Q!
I tried asking my Logger+ question to the Logger+ reflector but didn't get
a reply. Hoping someone here has the answer for me: When using N1MM
Logger+ and running stations, when I press the F2 key to send the
Logger+ exchange, the
exchange goes out on the current line, but I'd like this exchange to jump
to the next blank line as I believe it would be easier to see. Note: if I
edit the F2 macro and begin with a "ENTER" then the other stations Callsign
still gets sent on the current line and the report gets sent on the next
line. If I edit the F2 macro and begin with "Enter" and "!" then his
Callsign gets sent twice, once on the current line and again on the second
line.
When running, I only want to send the other stations Callsign one time and
I want it to be sent on the next line along with the report. It appears
that the F2 "run" macro has a default setting that cannot be edited during
the normal editing process. Please advise if there is a way for me to edit
the F2 "run" macro so the other stations Call is only sent once after
jumping to the next blank line?
Thanks!
Dick- K9OM
_______________________________________________
RTTY mailing list
RTTY@contesting.com <mailto:RTTY@contesting.com>
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|