It was happening when I was running. All of a sudden I would notice calls
not being decoded in the main window but was fine (with AFC on) in the
Additional RX window. The AFC button would be OFF in the main window and I
would need to click it back on.
Has not happened this afternoon. I am trying to think of something different
that I was doing this morning or yesterday.
Randy N1KWF
On Sun, Jan 9, 2011 at 5:56 PM, Dave AA6YQ <aa6yq@ambersoft.com> wrote:
> >>>AA6YQ comments below
>
> -----Original Message-----
> From: rtty-bounces@contesting.com [mailto:rtty-bounces@contesting.com]On
> Behalf Of Rick Ellison
> Sent: Sunday, January 09, 2011 5:44 PM
> To: rtty@contesting.com
> Subject: Re: [RTTY] MMTTY AFC Bug
>
>
> This is one of the things I was going to point out Bob..
> There are a few different settings in N1MM that will cause the AFC to turn
> off or on depending on what setting you have off or on.. One of them being
> send Ham Default on S&P/Run Change. If the AFC is turned on in the Default
> profile and this setting is turned on then the AFC could be turned off or
> on
> depending..
>
> >>>That's why I've asked if anyone running MMTTY standalone had experienced
> this behavior. So far, the only two reports have come from ops using
> WriteLog and N1MM; those applications could be directing MMTTY to disable
> AFC.
>
> 73,
>
> Dave, AA6YQ
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
--
Randy Lake N1KWF
73 Gunn Rd.
Keene,NH
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|