I concur with Barry, and I run my gain no higher than 90. I see absolutely
no degradation of signal levels, and it helps keep atmospheric and other
noise down, especially on the low bands.
I used my radio for hours over the weekend, and can't say I experienced any
overload on any band. I was so impressed with the DSP in the Orion,
compared to that of any other I've had (Yaesu 1000D's and MKV, and ProII)
Larry, N0XB
-----Original Message-----
From: orion-bounces@contesting.com [mailto:orion-bounces@contesting.com] On
Behalf Of Barry Gross
Sent: Monday, November 28, 2005 5:37 AM
To: Orion @contesting.com
Subject: Re: [Orion] 1.372
On 11/28/05, Christoph Rheker <christor@microsoft.com> wrote:
>
> Yes, same here, happens usually on the Low Bands.
>
> My Orion with 1.372 works great until receiver (DSP) is overdriven by
> strong signal- about S9 plus 30dB.
I work quite a bit of topband with my Orion and can't say that I experience
this problem. Have you tried turning down the RF Gain control?
73,
Barry N1EU
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|