Karlnet
[Top] [All Lists]

RE: [Karlnet] First install of Ubicom-based CPE...

To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Subject: RE: [Karlnet] First install of Ubicom-based CPE...
From: "Kevin Knuth" <kknuth@karlnet.com>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Fri, 27 Jun 2003 08:01:52 -0500
List-post: <mailto:karlnet@WISPNotes.com>
One of our distributors, Maplenet, has gone and made their own!

So yes, they are shipping!

Kevin

-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Dan Metcalf
Sent: Thursday, June 26, 2003 10:44 PM
To: 'Norm Young'; 'Karlnet Mailing List'
Subject: RE: [Karlnet] First install of Ubicom-based CPE...


These are shipping?

> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Norm Young
> Sent: Thursday, June 26, 2003 9:33 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] First install of Ubicom-based CPE...
> 
> I've got a couple of Ubicom boards enclosed in the AntennasAmerica
19dB
> panel/enclosure, and I'm trying to set one up for the first time.
Seems
> simple enough, with a web interface, can't mess it up, right? :)
> 
> However, after installation in a place I know has good signal (-84dBm)
via
> a
> Lucent Silver using the XP driver, I cannot get a signal.  There are a
> couple of possiblities, I think: 1) Wrong RF connector, or 2) the
Ubicom
> has
> much, much less RF sensitivity than the Lucent card. (Seems unlikely.)
> 
> Since I've had to swap these boards out, (got 802.11b instead of TC
boards
> by mistake) there is some question on which of the two RF connectors
to
> use
> on the board.  I've currently got it in the connector closest to the
power
> connector.    Swapping it over to the other seemed to make no
difference.
> 
> I've set the Ubicom to the base station channel, (auto
selection/scanning
> doesn't work) but it reports nothing.  The system passphrase is set
> correctly, but I don't see a place to enter the Network ID number like
you
> have to with the SR-4000.
> 
> Anyone else had a setup experience with this hardware?
> 
> Norm
> 
> 
> 
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]


---
[This E-mail scanned for viruses by Declude Virus]

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
<Prev in Thread] Current Thread [Next in Thread>