Re: [Karlnet] Erros in new karlnet bins

[Chris Conn <cconn@abacom.com>]

Leszek Olszewski wrote:
> Anybody else noticed them?
>
> After upgrading to 4.27 Preferred IP address on IP router setup doesn't
> work - no matter what I set the router presents itself with one of the
> other addresses assigned to interfaces (didn't find any real rule here).
>

Hello,

I have re-upgraded a few units to test, and I see this behaviour.  It 
seems to prefer to use an IP assigned to a wireless interface more than 
anything else...Most of my network is numbered with IANA 192.168.xxx.xxx 
addresses to not waste routed ip space, so I now have very ugly 
traceroutes on my upgraded units.

Anyone having errors upgrading?  I have some units that start to exibit 
packet loss, and then I get a "Error writing to network" error.  The 
unit reboots and stays at 4.02...If I drive to the site and upgrade via 
the ethernet port, I don't have this problem.

Also, for Demarc fans, I can select Security on units using Tony's 180mW 
 now so maybe WEP works with the Prism 2.5 cards?

Chris