wonder who's read the list welcome message lately (click amps link at
bottom of any of the messages)
DO NOT USE THIS REFLECTOR TO POST COMPLAINTS, PERSONAL CRITICISMS OR
ATTACKS, AND DISCUSSIONS OF LIST OPERATION, ETC. VIOLATORS OF THIS POLICY
WILL BE REMOVED IMMEDIATELY WITHOUT NOTICE.
Be considerate of other subscribers who have bandwidth limitations and edit
posts for succinctness (include ONLY relevant excerpts of previous posts).
NOTE: Top-posting complete previous messages are not allowed...please
either edit relevant parts of prior messages or delete them entirely. When
responding to a specific individual, think carefully before copying to the
other 1100 of us on the reflector.
Minimize noise, minimize bandwidth, maximize Amplifier information, act
like gentlemen and enjoy!
Please folks - Minimize noise!!
73
On Wed, Dec 28, 2022 at 6:26 PM Jim <jimw7ry@gmail.com> wrote:
>
> Thanks, 73, Jim W7RY
>
> On 12/28/2022 5:29 PM, n4is@comcast.net wrote:
> >
> > Whats a catch 22?
> >
> > You need to connect the Amp chassis to the AC neutral (wire connected to
> the
> > ground at the AC entrance), and you need to connect the Amp chassis to
> the
> > ground of the station, at same time, the ground of the station need to
> be
> > connected to the AC ground at the entrance. All neutral wires must be
> > connected to only one point!
> >
> > You cannot do both at the same time.
> >
> > If you don't isolate the AC house ground from the station ground, also
> > neutral, because it is also connected at the AC entrance, you end up
> with a
> > UNSAFE ground. RF can flow to the house, EMF generate currents on both
> wires
> > and you want the current to the ground, not to your house. It is a mess.
>
> > Neutral or ground are two names for the same thing,
>
>
> Wrong. They are separate conductors, only being common at the primary
> service disconnect.
>
> I'm out...
>
> Jim W7RY
>
>
> > a wire from the chassis
> > to a bar on the ground. But! The functionality is different, neutral is
> for
> > human safety, ground wire is low impedance path to the actual ground. A
> long
> > ground wire for the station is a problem, 10 ft long can became an
> antenna
> > for 28 MHz, a long neutral wire is not a problems, it works for safety,
> if
> > no current flow on it, no load.
> >
> > 73's
> > JC
> > N4IS
> >
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|