The amplifier's output antenna connector.
There are six programmable outputs on the 2K. Each can be configured to
utilize the internal tuner, if so desired, and to switch to a
predetermined antenna for a given band. The band switching can be
accomplished based on a band input from the transceiver's CAT port or RF
sensing of the input frequency. The port can be switched between one of
two transceivers either manually or automatically through RF sensing.
Each port can also be configured to change a Steppir to the band
corresponding to that selected by the transceiver/amp. The signal for
Steppir band selection is generated by the 2K and not the transceiver.
(I haven't programmed the amp in a while, but that's what I remember off
the top of my head.)
It all has worked flawlessly so far.
73, Joe
K2XX
On 3/5/2013 12:51 PM, Rob Atkinson wrote:
What's an "output port?"
Rob
K5UJ
On Tue, Mar 5, 2013 at 10:26 AM, Joe Giacobello, K2XX<k2xx@swva.net> wrote:
I've owned a 2K-FA for about 14 months now and it has been literally
trouble-free. (It was delivered with one of its six output ports
inoperative.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.2899 / Virus Database: 2641/6128 - Release Date: 02/24/13
Internal Virus Database is out of date.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|