Jim Thomson wrote:
>## where psud falls down.. is with dynamic loads. I wish they could
>simulate that. The original psud was for audiophile and stereo amp
>fellows. I see the latest version will allow a cap up to 1 farad.
>
PSU Designer will simulate a constant-current load which can step to a
different value after a specified period of time. This allows you to
simulate two levels of current draw and the worst-case step response
between them. The two currents are usually either off-load followed by
zero-signal anode current, or ZSAC followed by full key-down.
--
73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|