-------- Original Message --------
Subject: Re: [Amps] LK 500 ZA heat
Date: Mon, 13 Aug 2007 17:24:40 -0400
From: alexander a. aimette <w2ox@verizon.net>
To: dave arruzza <w1ctn@yahoo.com>
References: <444028.48950.qm@web38209.mail.mud.yahoo.com>
dave arruzza wrote:
>Hello to all...
>
> My LK 500 ZA gets very hot when operated for any length of time. I do not
> think that the stock fan is adequate for the job. I am planning on adding at
> least one fan externally to pull out some of the hot air from the 3-500Z's.
>
> Has anyone else had this problem? With the amount of heat generated I am
> sure that some other components inside that box are stressed from the extreme
> heat. I just want to alleviate this condition before other parts start to
> fail.
>
> I'm sure that the bandswitch problems associated with this linear are a
> direct result of the heat retained within the box.
>
> Any ideas and mods are welcome.
>
> 73
> Dave W1CTN
>
>
>---------------------------------
>Park yourself in front of a world of choices in alternative vehicles.
>Visit the Yahoo! Auto Green Center.
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>
dear dave: I have owned and ran 3 lk500za amps in contests for years.
Here are a couple of things you might consider, BASED ON ACTUAL
EXPERIENCE--NOT THEORY.. There is also the comment that advice is worth
what you pay for it!!!!
1-These amps are notorious for parasitics. EVERY ONE OF MY AMPS WAS
FITTED OUT WITH the Ralph Measures 3-500z parasitic suppressers and I
had no further problems--for 10 years, in every cqww and arrl test
during those years. I replaced just two 3-500z tubes in all that time.
2-Some of these amps have a low and a high fan setting. I always used
the high fan setting. There is also a temp sensing circuit which
switches the fan to a high setting with a higher duty cycle. If this
cicuit is not working that may be your problem..
3-The amps I had all were fitted with four fans in a wall behind the
tubes. Check that they all work. Also note that the fans are usually
very, very noisy on the high setting. If the fan noise is very quiet,
then the fans are NOT working at the high rpm setting.
4-If you are running the amp at the 3500 dc high volt tap instead of the
3100v tap on the xfmr(just switch to the high voltage indication on the
front panel, no load) you will have tuning capacitor arcing and
bandswitch arcing problems on any load other than 1:1 SWR. This amp is
not designed to operate at power levels of 1500w at other than 1:1.
My amps ran well at 1200watts into loads up to 1:3 SWR.. I ran all
of my amps at 1200-1300w MAX into low swr loads for years at v47kp
without problems.
If you insist on getting 1500w out, good luck!!
5-Drive power was limited to that which gave 1200w out, typically 70-100
watts depending on the band.
6-I never ran the amp with the full break in system.
alex aimette, w2ox/v47kp
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|