Gary Schafer escribió:
> That is the one Colin! That was my first hand book and I still have it. The
> binding fell apart and my dad later glued it with some cloth to keep it
> somewhat together. I still have it.
>
> The 4X250 amp article in there ran at reduced power as the cooling was not
> adequate for full power operation.
I also have that edition (although spanish translated by a local
editor). It
specifies 650 watts input, 1500 V plate voltage, 300 V screen voltage, and -40
V grid bias. And the input is an inductor in series (to rise the drive at 10
Mtrs.) with a 110 ohms resistor to ground, then a 470 pF to the grids each via
a 10 ohm parasitic resistor.
For those days Pi output transceivers.
Best regards
Guillermo - LU8EYW.
>
> The 4X250 family is ok to run in AB2 unlike the 4CX1000.
>
> 73
> Gary K4FMX
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|